WR001 - Tool To Remove Impeller - Solas
Price: $7.99
Save: $3.73
(31% Off $11.72)
Part # WR001
Full StarFull StarFull StarFull StarFull Star
2 Customer Reviews
Write Review  |  Ask Question
Solas
Description Customer Reviews Customer Questions & Answers Shipping

Impeller Accessories & Installation Guide
Honda Impeller Accessories & Installation Guide
  1. Remove and separate the whole jet pump from the PWC.
  2. Remove the trail cone (or cap) from the stator.
  3. Hold the rear end of the shaft with a bench vise. Remove the impeller with an impeller wrench. Turning counter clockwise will loosen the impeller.
  4. Visually inspect thread on shaft & impeller for debris or damage. Apply grease or anti-seize on the thread before installation.
  5. Screw in the impeller by hand; be careful of the sharp edges of the impeller. Tighten with the impeller wrench. If the impeller feels too tight or not threaded properly, unscrew the impeller, clean and check the thread.
  6. Assemble the pump and put it back on the PWC.
*This installation guide is suggested for reference only. Please refer to your service manual for procedure details.

Average Customer Review for WR001 - Tool To Remove Impeller - Solas
Full StarFull StarFull StarFull StarFull Star
Based On 2 Reviews | Write Review
Full StarFull StarFull StarFull StarFull Star
WR001
by Denis from Candiac, Quebec on May 27, 2012
fast delivery very good tool
Was this review helpful?
Full StarFull StarFull StarFull StarFull Star
Impeller Tool
by Michael from Ledbetter, Kentucky on September 24, 2011
A must have to remove impeller to replace wear ring or to use in pto side of motor to hold or to turn over motor.
Was this review helpful?
This product ships in 1 business day.
Add to Cart and enter your Postal Code to determine the shipping charges.
Most products and orders leave our warehouse in 1 business day. However, select items may take more processing time. Alaska and Hawaii orders please add 1 additional warehouse processing day.
Standard Shipping Policies