Tiger Shark PWC Impeller Accessories

The iBoats Experience

Browse thousands of constantly-updated listings and search by location, brand, and boat type See more...

Connect with our expansive community and tap into the knowledge base of the most dedicated boaters around. See more...

Browse and search for hundreds of thousands of boat parts, accessories, and supplies to suit your every need.

View Larger Photos

Impeller Accessories & Installation Guide
	Remove and separate the whole jet pump from the PWC. Remove the trail cone (or cap) from the stator. Hold the rear end of the shaft with a bench vise. Remove the impeller with an impeller wrench. Turning counter clockwise will loosen the impeller. Visually inspect thread on shaft & impeller for debris or damage. Apply grease or anti-seize on the thread before installation. Screw in the impeller by hand; be careful of the sharp edges of the impeller. Tighten with the impeller wrench. If the impeller feels too tight or not threaded properly, unscrew the impeller, clean and check the thread. Assemble the pump and put it back on the PWC.
*This installation guide is suggested for reference only. Please refer to your service manual for procedure details.