Johnson Power Tilt and Trim Motors

Well this the motor to the complete set up. So if you need to just replace the motor then yes this is all you need. Just be sure it works for your application.

Yes.

First - Remove the bolt and the pin securing the cylinder. Once this is done, loosen the engine mounting bolts. Top and bottom on both sides. Don't remove them. Just loosen them to the end of the threads. Next, I used a half inch thick piece of plywood against the hull of the boat beneath the engine mount and used a thin pry bar to lift the bottom of the engine away from the boat. I then jammed another piece of plywood in the top between the engine mount and the hull to hold the engine in place. This allowed me JUST ENOUGH SPACE to get a short 7/8 socket on the bolt and remove it. I hope this helps anyone who reads this.

When it comes to mechanical advice, we cannot offer any because we are not trained to do that. You will need to refer to a repair/service manual, or you can connect with thousands of boaters on our forums at https://forums.iboats.com. Or you can check out our repair/service manuals: http://www.iboats.com/Boat-Motor-Repair-Manuals/dm/view_id.1

Sierra does not have that information. We can only guarantee it to work based on the OEM number. If you need further assistance call us at 1-800-914-1123.

No it is not. Your OEM number is FK654541 which is obsolete. So you will need to contact an obsolete outboard parts dealer or see if a local Mercury dealer can get one.

Yes this will work for your outboard.

You need part number 18-6280.

Yes this will fit your outboard motor.